2 Positioning rings for aerial hoops.
1 x 4 mm Allen key.
1 Instruction sheet with QR code.

2 Straps
1 Carabiner

1° Using the 4 mm Allen key, unscrew the 2 screws already fitted on the ring counterclockwise and remove them completely to separate the two parts. The lower half can be identified by the housed nuts. 

2° Place the two halves of the ring around the hoop at the desired point, making sure that the half with the housed nuts is positioned at the bottom, and align the two parts perfectly.

3° Reinsert the screws into their dedicated slots and tighten clockwise using the 4 mm Allen key, until fully tightened. Make sure they are securely tightened, without applying excessive force to avoid damaging the components.

4° Repeat the procedure for the second ring.

It is recommended to position one of the two rings near the hoop weld, to prevent it from causing discomfort during use.

The distance between the two rings can be freely chosen according to personal preference and intended use.

5° Position a strap (not included) around one of the two rings. Make a cow hitch knot, tightening it so that the strap fully wraps around the ring and remains securely in place.

6° Repeat the same operation for the second ring, using a second strap (not included).

7° Insert the free end of each strap into a carabiner.

8° Connect the carabiner to a suitable anchoring system, making sure that a swivel is present along the main suspension line.

3.1 When tightening the ring screws, do not apply excessive force, to avoid damaging the components.

3.2 Before each use, check that the straps are in optimal condition and show no signs of wear or damage.